De rode ridder
Senior Member
- Joined
- Sep 19, 2011
- Messages
- 623
- Reaction score
- 65
According drawing 50361 the rear seat bottom plywood measures 1/4" x 15 1/4" x 18". That seems small. If I compare this with drawing 50503 rear seat installation and 50861 rear seat cleat, the width should be 24 ?/8" (can´t read the exact figure)
This would mean that that the actual plywood would be much smaller then the cleat,.... meaning the cleat sticks out a lot on both sides of the bottom.
The seat installation drawing doesn´t show this and when I look at many L4 pictures either. Is the dimension of the rear seat bottom drawing 50361 wrong????
Either way, the 15 1/4" x 18" looks small. It would fit on it but probably won´t in 20 years
.
What is wrong here?
My question; what is the correct size of the plywood?
something like 18"x23 3/4"????
I can´t read the hardware listed on 50503 either. What type of screws, nuts and washers did you use for attaching the channels and cleats???
View attachment 50361.pdf
This would mean that that the actual plywood would be much smaller then the cleat,.... meaning the cleat sticks out a lot on both sides of the bottom.
The seat installation drawing doesn´t show this and when I look at many L4 pictures either. Is the dimension of the rear seat bottom drawing 50361 wrong????
Either way, the 15 1/4" x 18" looks small. It would fit on it but probably won´t in 20 years
.What is wrong here?
My question; what is the correct size of the plywood?
something like 18"x23 3/4"????
I can´t read the hardware listed on 50503 either. What type of screws, nuts and washers did you use for attaching the channels and cleats???
View attachment 50361.pdf
Last edited:
