It appears that my fuel tank mounting brackets, the ones welded to the fuselage require a fully threaded AN 3 size screw or an 8-32 size screw. Problem is that it has to be about 3.5 inches long to capture the two halves of the tank mounting straps and then get them cinched down. Also, the 10-32 screws that are used to block the travel of the right left motion of the control stick in the back are needed.
If anyone can give me a part number for those, or whatever it takes to order such animals I'd apprectiate it. I've gone through aircraft spruce front to back and can't find anything that will do the job because of the lenghts I need.
Also, I've looked at my original engine mounting bolts, and they "look good." Is there any reason that they should be replaced at any interval? If so, I'd appreciate a part number for those as well. They are an AN6-25, but I suspect they are a special bolt with a specific part number...extra strong or some such.
If anyone can give me a part number for those, or whatever it takes to order such animals I'd apprectiate it. I've gone through aircraft spruce front to back and can't find anything that will do the job because of the lenghts I need.
Also, I've looked at my original engine mounting bolts, and they "look good." Is there any reason that they should be replaced at any interval? If so, I'd appreciate a part number for those as well. They are an AN6-25, but I suspect they are a special bolt with a specific part number...extra strong or some such.