The summer is over and my priorities are shifting from flying to working on my J3 project. I purchased a set of wings and am getting ready to cover and paint. I fitted the uncovered wings to the fuselage to check for fit etc. and noticed that the pulley that is attached to the center hinge fitting is not lined up with the front pulley that directs the cable down the strut.
I think the fittings should be reversed from one wing to the other but I thought that I had better run this by the forum.
Here is a pic of the left wing fitting looking at it from the rear.
Thanks,
Joe
I think the fittings should be reversed from one wing to the other but I thought that I had better run this by the forum.
Here is a pic of the left wing fitting looking at it from the rear.
Thanks,
Joe