Become a Subscribing Member today!

J3-Cub.com is the largest community of J3-Cub pilots, owners and enthusiasts. With over 1000 active members, we have fostered a vibrant community and extensive knowledge base.

Access to the J3-Cub.com community is by subscription only. Membership is only $49.99/year or $6.99/month to gain access to this community and extensive unmatched library of knowledge.

Why become a Subscribing Member?
- J3-Cub.com hosts a library of over 13 years of technical discussions, J3 data, tutorials, plane builds, guides, technical manuals and more.
- J3-Cub.com also hosts an extensive library of J3-Cub photos.
- You will also receive two J3-Cub decals!
Become a Subscribing Member and access J3-Cub.com in full!
Subscribe Now

Aileron balance cable pulley bracket

Thread starter Nigel Hitchman
Start date Jul 20, 2021

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Nigel Hitchman

Well-Known Member

Supporting Member

Jul 20, 2021

I’m getting my wood spar wing ready for covering, just installing the brackets for the aileron balance cable pulley attachment to the rear of the front spar at the top of the strut. These mount with a spacer on a bolt attaching the aileron attaching brackets to the spar.
my question is, should this bracket be free to rotate slightly, so the pulley can line up with the natural lie of the cable, or should they be tight and presumably parallel with the spar? I’m talking about the bracket that attaches to the bolt going through the spar, not the bracket that holds the pulley which is attached to this.
hopefully I’ve managed to attach a poor picture of the bracket!