- Joined
- Apr 12, 2018
- Messages
- 242
- Reaction score
- 67
For those with a tail navigation light installed on the rudder, how did you run the wiring?
Fat Cub's wires ran up the vertical stabilizer leading edge tube. Went back to tail post inside top channel of stabilizer. Then proceeded up to the rudder through the fabric covering the top of the tail post.
Is that the normal way?
How do you help prevent wire fatiguing from rudder movement?
Thanks in advance.
Fat Cub's wires ran up the vertical stabilizer leading edge tube. Went back to tail post inside top channel of stabilizer. Then proceeded up to the rudder through the fabric covering the top of the tail post.
Is that the normal way?
How do you help prevent wire fatiguing from rudder movement?
Thanks in advance.