Gift Premium Subscription To jb57tub

Join Date:


Last Activity:

01-14-2018 4:12 AM

Likes Given: 2

15 Likes on 8 Posts 


  • Posted in thread: Flooded cub in texas on 09-01-2017 at 02:13 AM
    Here is our hanger in Rockport, Tx. My Cubby fuse is in the middle of the pic, covered by the
    sheet metal from the walls. The yellow Cubby in the back was in another hanger attached to
    ours, was on fl...

  • Posted in thread: wing wash-out on 08-22-2017 at 02:15 AM
    Reileyr, Thank you for the reply. That's what I had seen with the aluminum ribs, but didn't
    know about when to do it for the wood ribs. Again thank you. Jon

  • Posted in thread: wing wash-out on 08-21-2017 at 10:08 PM
    Building a wood wing Wag cubby. Getting ready to glue the ribs to the spars. When is the best
    time to shim the spar for wash-out? When I do the initial gluing,wait till I trammel, or do I
    wait till I ...

  • Posted in thread: "Hide and Cub" on 05-18-2017 at 10:00 PM
    Cool Jorgen,Looks like the mustard fields in bloom I saw around Dijon, France several years
    ago. Was just about this time of year. Jon

  • Posted in thread: wing tip bow on 05-18-2017 at 09:55 PM
    Thank you for your replies. I was ordering other parts and WA was going to have to back order a
    few, so instead of splitting the order, I just ordered from Spruce. Thanks for the tip Bob,
    will have to...

  • Posted in thread: wing tip bow on 05-17-2017 at 05:47 PM
    Has anyone used Wag Aeros wing tip bows on their refurb? I want to order a couple and I need a
    few other parts, but just wondered about their quality. Ready to start assembly of the wings
    and don't wa...

  • Posted in thread: 90% done, 90% to go! on 04-24-2017 at 04:29 AM
    Nice! Keep it going! I'm at about the same spot as you. Mine will just be a beater, but it sure
    is fun. Your workmanship is outstanding. Jon

  • Posted in thread: Texas Parking Question on 03-17-2017 at 12:23 AM
    When is this trip going to take place? Where in Minnesota are you going? Jon

  • Posted in thread: Crack in the gas tank on 03-01-2017 at 01:12 AM
    In reference to removing that nut from the screw, have you tried what I call a Z screwdriver?
    It has a blade on each end, usually 90 degrees to each other. One blade with 90 degree bend on
    the shaft p...

  • Posted in thread: a little progress on 02-24-2017 at 05:59 AM
    Making a little progress on my Pa 11/ L4 Cubby. Fitting up the engine next. Tail feathers are
    built and covered, and all controls done. All glass and frames are done. Boot cowl done. Panel
    built, but ...